Method and disclaimer

FaultDesk is a small, independent reference for embroidery machine error codes. The goal is simple: when a machine stops, the person at the machine should get a useful answer in under a minute.

How the data is built

  1. Public sources. Error-code tables from manufacturer manuals and support bulletins are collected and normalized into one schema: brand, series, code, meaning, checks, systems.
  2. One row per query. Each code gets its own page because each code is a real search query. No spun pages, no “10 things you need to know” filler.
  3. Human review. The first batch is manual-derived. Codes are checked against the source PDF before publishing. The page links to the source so you can verify it yourself.
  4. Shop-floor rows. A few codes have no published table at all. Those rows are written from shop-floor reports in repair forums, cite the thread instead of a manual, and say “What the source says to check” rather than “What the manual says to check”. They are marked verified: false in the public JSON.
  5. Feedback. If a fix works or fails on your model, the correction is recorded. The dataset should get better with use, not just bigger.

Sources in this build

SourceNote
Barudan America — XS/XY Error MessagesBarudan XS/XY series error messages. Verify against your exact model and manual.
SWF / Coldesi support — Errors 101, 102, 103 and 300SWF support bulletins. Verify against your exact model and manual.
DigitSmith forum — Error message #300Shop-floor report from a forum thread, not manufacturer documentation: the original poster reported 300 with "Needle position signal does not vary", and a reply cleared it by selecting another needle number. No SWF table for this code was found.
DigitSmith forum — SWF Error 707 “Doc Broken”Shop-floor reports from a forum thread, not manufacturer documentation: replies were “Reinstall the software” and “Flash Memory Not Found”, and one poster asked for the CPU model, which suggests the answer depends on the board revision. No SWF table for this code was found.
DigitSmith forum — SWF 1201 “Not Load Design”Shop-floor reports from a forum thread, not manufacturer documentation. Replies: “no design in memory, load from floppy/serial/USB”, and “if the memory is too full it will not load, delete stored designs”.
The Embroidery Warehouse — Tajima Machine Error ListManual-derived error list. Verify against your exact model and manual before repairing.

What this is not

Not official. FaultDesk is not affiliated with Tajima, Barudan, SWF, or any manufacturer. Manufacturer manuals are the authority for your exact model and serial number.

Not a full manual. Pages quote short factual descriptions and checks from public sources. They do not reproduce complete manuals or wiring diagrams.

Not a substitute for a technician. If a fix involves a board, driver, motor, laser, or replacement part, stop and call a qualified technician. Do not run production with an unresolved fault.

Corrections

If a page is wrong for your model, the page should say so. Until the correction form is live, the rule is: keep the source link, record the model and serial number, and treat the manual as the tie-breaker. A correction that includes the manual page number is worth ten forum guesses.

Why this exists

The current search results for a specific code are usually a PDF, a forum thread, or a dealer’s phone number. That is a bad experience at the moment of downtime. A structured row with a source, a quick answer, and an escalation rule is better for the human — and it is the same row an agent needs when it is asked to diagnose a machine.