Browse embroidery fault codes by system

Start with the part of the machine that is complaining. Every row in the dataset is tagged with the systems it touches, so the same list works for a Tajima, a Barudan, and an SWF.

Sensor

42 codes and messages

Sensors tell the controller where the frame, needle, thread, and moving parts are. A sensor code can be a dirty lens, a loose connector, or a failed sensor.

Design

41 codes and messages

Design codes come from the stitch file, the hoop, or the path the machine is trying to sew. The machine is usually telling you the file and the setup do not agree.

Frame

29 codes and messages

Frame codes cover pantograph movement, travel limits, and the frame drive. A frame code can be a jam, a loose belt, or a limit switch.

Motor

22 codes and messages

Motor codes cover the main motor, the X/Y motors, and the trimmer motor. The controller saw a motor that did not move, moved too far, or drew too much current.

Memory

19 codes and messages

Memory codes cover the machine's internal storage and the design transfer. They often appear after a file is interrupted or the memory is full.

Power

19 codes and messages

Power codes cover the supply, the emergency stop, and the power board. They are the codes where guessing is most expensive.

Thread

19 codes and messages

Thread codes cover breaks, run-out, the thread path, and the bobbin. Most are mechanical: a rough guide, a bad spool, or a tension that drifted.

Needle

17 codes and messages

Needle codes cover needle position, needle breakage, and the needle bar. A needle code after a break is a warning to check the timing, not just the needle.

Communication

10 codes and messages

Communication codes cover the link between the machine and a PC, USB drive, or network. The machine and the other end are not agreeing.

Tension

9 codes and messages

Tension codes cover the upper and lower tension. The machine is reporting a tension it cannot explain, not necessarily a broken sensor.

Trimmer

9 codes and messages

Trimmer codes cover the thread trimmer, the waste bin, and the trimmer motor. A trimmer fault can stop the machine mid-design.

Bobbin

8 codes and messages

Bobbin codes cover the bobbin winder, the bobbin sensor, and the bobbin case. They are often a bobbin that is not seated or a winder that is not turning.

Encoder

8 codes and messages

Encoder codes cover position feedback. The controller cannot confirm where an axis is. This is usually a connector, contamination, or a failed encoder.

Pneumatic

7 codes and messages

Pneumatic codes cover air pressure, valves, and the air supply. The machine needs pressure to clamp, trim, or move an actuator.

Laser

6 codes and messages

Laser codes cover the positioning laser and its alignment. They are usually a laser that is off, blocked, or out of alignment.

Lubrication

4 codes and messages

Lubrication codes cover oil level, the reservoir, and the lubrication schedule. They are a maintenance reminder as often as a fault.

Or browse all 188 codes and the brand hubs.

Machine down right now? Send the code and model. We’ll reply with the next step.
Request a repair callback →
How to use this page. These are system-level starting points, not code-specific repairs. Open the code page for the manual’s checks, and call a technician when the page names a board, driver, motor, or laser.