SWF support bulletins

SWF 300: Needle position signal

error needleframe Updated 2026-11-20
Quick answer SWF 300 means The needle position signal is not changing, so the control cannot confirm the needle position and the head does not line up with the needle plate. First check: Press any needle number on the keypad as if changing needles.

What it means

The needle position signal is not changing, so the control cannot confirm the needle position and the head does not line up with the needle plate.

This page is generated from a public source: DigitSmith forum — Error message #300. It is a starting point, not a substitute for the manual for your exact model.

This code is tagged needle, frame. Browse all needle codes.

What the source says to check

  1. Press any needle number on the keypad as if changing needles.
  2. Wait a few seconds for the machine to re-index.
  3. If the message returns, call a technician.
From the shop floor. One owner was told to press any needle number on the keypad, as if changing needles; the machine re-indexes and the message clears within a few seconds. Original thread.
When to call a technician. This code can involve a board, driver, motor, or replacement part. If the checks above do not clear it, stop and call a technician rather than guessing.

Not sure whether to keep going? Read when to call a technician or how to read a code.

Repair deskNo. ______

Still down?

Send SWF 300 to a technician. Tell us the model and what the machine is doing. We’ll reply with the next step: a remote check, a part, or someone who services your area.

Request a repair callback →

No account. No charge to ask. If the machine is mid-order, say so in the notes.

Related SWF codes

FAQ

What does SWF 300 mean?

SWF 300 means: The needle position signal is not changing, so the control cannot confirm the needle position and the head does not line up with the needle plate. It is an error code and should be cleared before production.

How do I clear SWF 300?

Start with: Press any needle number on the keypad as if changing needles. Then: Wait a few seconds for the machine to re-index. Then: If the message returns, call a technician.

When should I call a technician for SWF 300?

If the checks above do not clear the code, or if the fix involves a board, driver, motor, or replacement part, call a technician. Do not keep running production with an unresolved fault.

Source: DigitSmith forum — Error message #300. Shop-floor report from a forum thread, not manufacturer documentation: the original poster reported 300 with "Needle position signal does not vary", and a reply cleared it by selecting another needle number. No SWF table for this code was found.

Corrections: if this page is wrong for your model, keep the source link and the model/serial number. The correction process is described in Method & disclaimer.