Tajima sensor error codes

The 36 Tajima rows tagged sensor in the FaultDesk dataset. Sensors tell the controller where the frame, needle, thread, and moving parts are. A sensor code can be a dirty lens, a loose connector, or a failed sensor.

What to check first

  • Clean the sensor and its reflector with a dry, lint-free cloth.
  • Check the connector at the sensor and at the board.
  • Look for a physical obstruction or a bracket that has moved.

System-level checks. Open the code page for the manual’s steps.

CodeMeaningType
08PTR tape signal troubleerror
211A fixed position signal is not detected. Main shaft Z signalerror
253Lower limit of the laser protect cover is not detectederror
254Upper limit of the laser protect cover is not detectederror
281Target needle position not detectederror
3A1The thread trimming driver has issued abnormal signalserror
3D1There is abnormality in a battery backup signalerror
3D2There is abnormality in a battery backup signalerror
3D3There is abnormality in a battery backup signalerror
3F3The thread tension release driver has received an abnormal signalerror
3A8A thread holding driver error signal is detectederror
311Encoder A signal status does not change for 5 seconds. Motor or…error
312Encoder z signal status does not change for 5 secondserror
314Main shaft rotation failureerror
317The take-up lever clutch has received an abnormal signalerror
322An X-axis pulse motor driver error signal is detectederror
323A Y-axis pulse motor driver error signal is detectederror
325Absolute origin could not be detected on the X or Y axis. Cap…error
341An M-axis base point signal is not detectederror
342An M-axis PMD abnormal signal is detectederror
345The M-axis clutch driver has received an abnormal signalerror
346The zig-zag PMD has received an abnormal signalerror
347An M-axis PMD abnormal signal is detectederror
352The sequin driver has issued abnormal signalserror
371Either an upper or lower position signal cannoterror
373The nipple position sensor issued an abnormal signalerror
374Nipple sensor signal abnormality, both inputs have signalserror
375The Z-axis driver (Z-axis release solenoid) has received an…error
381FX head needle position input errorerror
382The needle position signal status during color change does not…error
383Incorrect input of needle positionerror
385Lens does not move to the designated position when during lense…error
391Thread release input signal errorerror
51No stop position signal is outputerror
56Color change, half-turn cam signal troubleerror
57Needle position signal troubleerror

See all sensor codes across brands, or the Tajima hub.

Machine down right now? Send the Tajima code and model. We’ll reply with the next step.
Request a repair callback →
Source: public manuals and support bulletins, linked from each code page. Independent and unofficial. Verify against the manual for your exact model.